Plaster wall.
The final finishing will be a zero-wallpaper / net and dazhoma. As in
trowelable the drywall seams are necessary for the layers.
Do you need a paper tape, or just uzhtenka rodbandu or uniflotu and
ground?
then light, then nothing is free in the bar and not much work out there more. After all,
uniflot by technology type as a band and he should not ..
Rotbandas not for seams, make no mistake. You need to:
Fugenfüller Leicht + reinforcement bar
or
Uniflott reinforcing bar is not necessary
or
Duct tape + reinforcement
or
IGIS.T + reinforcement bar.
The arming putty and not harder sveiciasi uzbaigiamajam
layer is uzarmavus and everything idziuvus uzbaigciau easy simple
Filler (microspheres acquire MR, etc.). easily sveiciasi, and can be extracted
perfectly smooth surface, I suggest that depressions will remain invisible.
is not, but stable konstrukcijoj he resorted nothing wrong. Several'd suggest it to me and no one uztepliotos a couple of neskilo, and instead of holding the judresnej or channels, or someone vetonit
Related Articles:
I work with the plaster for more than 15 metu.pats himself erect house, everything I laid with plaster, and no one is 4 years old hole. that due to gypsum constructions trukines-bluff. Everything depends on how ready glaistytojai. I myself from the seaside, and when atsikrausciau here in Vilnius, was struck as a foundation for working here glaistytojai.ateina immediately Bonding netting after uzglaisto spaces nuglaisto and finally painted. some cracks in the seams, and then convene the bad plaster built. evolutionary explanation, and a hundred times proven technology gruntavimas.2 .1-gypsum-thread, screw-grid glaistymas.3 klijavimas.4-again offering daubing. 5-daubing all plates. the main point is that if the grid has to be infused into the mass (blue fugenfiuleris), and all make the mistake of believing that stuck netting fugenfiuleris penetrating through the net. seams should be covered with about 4-5 times. I did a lot of friends object, and even where there have already given a guarantee that the seams will last (it was one of the corner of the foundation collapsed in the ground), unfortunately not completed.
Mix to be very small roundabout with a mixer or by hand with a spatula, then quite a nest.
Shaken with a mixer instantaneous cures.
Walls used to acquire makrosfera / microsphere
fiuleri uniflota and I heard Bert just should not saujom into the water, then
some time expected, the swelling ... and of course in very small quantities, as in
time bucket spillage, because he believed so i kazko rotbanda :) This is just
I managed to come out when he began to translate kietet
maybe explained in more detail how to handle the edges of the GCP are not mill? whether they need to cut grooves Koki? AIP there to deal with those seams? explain in more detail.
primitive way: both plates at right angles with a knife (or anything else) set off a 45-degree angle to the sides Similarly, the plate thickness frosting the combination sink and netting of knowledge ...
SHEETROCK Popirius better, better quality than the Polish, there are already many places, at Kaunas (Santer, for example).
Fugenfuller is the main filler and offering better access Uniflota (if Knauf) and French analogues Kender SE86 (better to remain longer in employment, stronger glue). This is the best quality achieved.
Painting trowelable 4 times, 2 and 2 Fugenfuller SHEETROCK. Upon completion and start scrubbing glazed. Grounded.
Wallpapers trowelable 2 times.
Grid not figure anything at all because, unlike the paper does not micro-fiber which is compensated for walking.
Incidentally, the largest V-shaped cut katlavanus does not make sense because the same gypsum nesuklijuosi each other, too fragile. All the time the paper.
If you buy kampukus, toj pacioj Santeroj Kender company is aluminum. 3m - 4lt, but is probably best. Senukuos kampuku nothing unsafe, and there are always curved.
Before the addition of defatted not forget your Nefrasu or other diluent. Klijuojasi them out of trouble and Fugen, but as the glue is poor. Better Kender CE78, very good adhesive, although its function while daubing with reinforcing bar. The drawback is that little "leak".
Nzn what even say it again, my comments and dune Postini as their own? I have no packaging, but what I zin .. and if the comments have deteriorated to some extent at least why it is so and not otherwise. The 45 degrees useless, just a waste of unnecessary filler. For the same gypsum nesuklijuosi, time just paper ..
copy, after all, or so as they have already written somewhere. often can not read everything, but I want to take all the info I would be on the topic in one place. Postini and lazy because of their own to enter it each time the author, and have so much time to devour. to anyone in need, where you will select the most true and, if not all. if not use 45-degree angle, requires a very different way as a filler and the raso
Aruna, need advice, your contacts, email me i kestutis.dinda @ gmail.com