What would you recommend for use in this situation: in the village foundation concrete barn split at one point during the entire width (field side of the hole to a few mm) of rain, or just ground the ingress of water during winter thaws inside the lake, although it seems an attempt to patch the concrete ( truth from the inside ). The better apply the decomposition of the good adhesion, leaving no holes and slash retained after the winter? I suggest only apply cement on the outside but really is not any better options?

similar, though inferior to the problem is not valid and well - a tie between the land market is running into the well (as far as junction is submerged under water, outside - under the ground) - to apply to hold?

As with elastic pabandyciau tile adhesive. Stick well. Water miss.

Sito not recommend any of the wells. Little spread out over time.
The standard method of sealing the well junctions - packed clay
perimeter.

"Just cement will not help you. It should be spread and deepening of the gap so that
can be placed ~ 20-30mm thickness. Fill out the field for tile
adhesive or expanding cement mixture with hydrophobic additives.

Have I mentioned that the process should be the length of the crack?

Depending on what the foundation is, perhaps easier išdubasinti
and a new piece of išbetonuoti? Technologically it should be about 30 inches wide.

Ceresit CX5, CX1
privaryt the syringe into the slot.

What about 20 cm prigreziociau splits into the plys, water and prisvirksciau
go to drink beer. After drinking a bottle, and carry out a structured makroflekso Bambals
privaryciau through those holes that filled every cranny.
Basta.

Related Articles:

1. Heated floors, or a film between the concrete and foam?
2. Foundation insulation should be of practical advice
3. Laying concrete blocks