left me on the ice, "the feeling that the building is a crisis ....: DDD
It should be folded about 60 square blocks of concrete, will do the same ...
Background filled, suvibruotas, I will put pads on the sand-cement mixture
level did that piltusi about 3 inches of the mixture.
Many searched the internet but I do not understand how it should be laid in the same blocks
or going to lay the pad already installed or can not climb on
without a vibrator, that is going to lay the basis for
The problem is that there is no choice of where to lay blocks, because the area
enclosed on three sides, the spacing between the buildings with closed-ended fence.
Blocks "Granite" 10x20x6, there is enough space to trigger placing next to each other or need to leave more?
How long can stand idle sand-cement mixture, and nepaklosiu
blocks during the day and carry a mixture of a small amount of expensive ...: (

Laminate lay the basis for walking, climb to, but if instead of the Malss
rimfire paving the bend them if they want to lay the paving is
What kind of OSB Laminate Galaba pasiklot

enough space is there are pads on the sides Majaka

Smell-mixed cement if you will not get too much moisture, it can stand as far as
wants to

Combined height of blocks, if you still need nesuvibruota protected from heavy rain,
that nepaplautu
Do not forget your on the tip with a few spaces to fill up the paving stones
dust pads will get stability, otherwise i Beto spaces prisines
all sorts of organic and grass to start growing

ps. If you bought the granite blocks which had gone to the defective
technical harmonization of the line when it goes wrong :)

DEK on the screenings will not have to hassle with cement mortar.
order:
Additional screenings, a little more (about +1-2, inches from the specified level. Your
the case of 4-5cm);
Trombuoji-all;
Nusibrauki-board with hospitalized vamzdzzius or by another method (eg
using curbs as Majaka ");
-Laying the blocks have already installed on my knees on the paving, dedi pe space (the
already have bumps on the sides, which is enough). Compare offers if necessary,
This is the tip pastumdai spade (or a rubber mallet to tap from behind)
every four-five rows;
-Additional screenings on top, wipe them;
Sutrombuoji-all (with the sole should be rubber);
Then again, everything atsijom dressing and a mop uzsluoji all spaces
(Repeat steps until all spaces pour);
-Atsikemsi you to enjoy your beer and work

As much as I explained trinkelistai - has the ability to pasiplauti screenings,
issiguleti. Therefore, after several years, for example, where machines often built, teoj
formation instead of concave. With dry concrete mix such problems fall away
At least in the running ... be best played only with a dry concrete, elsewhere
possible but with atsijom ...

wash may, if a large rubble poured. and then falls into the gaps. if sutrombuota crushed more or less homogeneous, no one anywhere neissiplauna.

There is a real example. Colleague yard with atsijom did it after
4 in the garage already zymu recess ...

screenings perfect to 3cm. chips are designed to match the ground roughness and
protrusions pebbles. as thinly as possible - the better, but in reality thinly than
three inches hard will succeed.

also I want to ask a few check-subject (12 m2 nevazinejama):
1.Ar for the last layer of graded gravel-mixed cement (wholemeal
diatomite was used for the base, leaving enough for a small area (12 m2);
2.Ar blocks laid on loose sand-cement mixture (the last 2-3
cm layer) or on suvibruoto (only slightly compared with a ruler);
3.Ar last layer should be 1cm taller than the beads (due to
Seat).
4.Koks recommended slope?
5.Ar Butina concrete curbs are all based or only local connections (~ 20
cm).
6.Kokiu height from the ground apibetonuoti overlap the sides.

Second nesuvibruotas the same top, then the sum over the pads is
rubber vibralke passes, some sit
Third the mood, as nedaryciau, because if you associate it looks awful, self-
Unfortunately even below, to curb the Upper body nuskalpuotis edges, ie
1 cm below, the water right at me fled to drainlainus, if necessary, to flee
bardiura through, then have a Laminate level by
4th Conceptually, the higher the water will run better but ... but to be perfectly
enough to do it so what 0.5%
5th by improving the basis of the work and what is not there more
6th negriutu that (according to the situation) and not too much, then block
neprieis :)

First for

Second Laminate on suvibruoto as unequal in different layers can
Sit down trombuojant

The third belongs

4th min of 1%, because the pads at the tiles, perfectly arranged. otherwise you may be skating.

5th If machines do not do it, it makes no difference

Related Articles:

1. Moss between paving
2. Cracked concrete foundations: the patch?
3. Eternit slate resurfacing
4. Heated floors, or a film between the concrete and foam?